0

(800) 327-3248
(561) 848-9628
MONDAY - FRIDAY 8AM - 5PM EST

FSSS Single Cartridge Housings

FSSS Single Cartridge Housings

Commercial / Industrial

Designed for 300 psi in 304 or 316 stainless steel.

 
FSSS Series Filter Housings are designed with a double o-ring compression which allows for positive sealing and easy access. Offered in DOE (double open end) or 222/Flat configurations.

 

Features
  • 304 or 316 stainless steel construction
  • 300 PSI (20.7 bar) pressure rating
  • Electro-polished finish Offered in Double Open End or 222 / Flat configurations
  • Double o-ring compression seal for easy change out
  • Includes 1/8” NPT vent and 1/8” NPT drain
  • Inline design for easy installation
  • Knife edge seal at both cartridge ends to eliminate by-pass for DOE cartridges
  • Standard with wrench and mounting bracket

Applications
  • Food & Beverage Filtration
  • Reverse Osmosis Pre-filtration
  • Process Water Filtration
  • Cutting Fluids
  • Lubricants
  • Plating Solutions
  • High Purity Water
  • Inks


Cartridge Diagram
Ordering Information
Ordering Info Chart
Filter Specifications
  • Finish - Poly Coat standard (exterior only)
  • Inlet/Outlet - 2” MNPT, 3” flange, 4” flange
  • Construction - 304 stainless steel standard, 316 optional
  • Closure - Band clamp closure, O-ring, Buna-N
  • Pressure - up to 150 PSI (10.3 bar) max
  • Temperature - up to 250°F (121°C); filter housing only

 

Pressure Drop Chart


Note: This publication is to be used as a guide. The data within has been obtained from many sources and is considered to be accurate. Harmsco does not assume liability for the accuracy and/or completeness of this data. Changes to the data can be made without notification. Temperature, Pressure, Flow Rates, Differential Pressures, Chemical Combinations and other unknown factors can affect performance in unknown ways. Limited Warranty: Harmsco warrants their products to be free of material and workmanship defects. Determination of suitability of Harmsco products for uses and applications contemplated by Buyer shall be the sole responsibility of Buyer. The end user/installer/buyer shall be liable for the product’s performance and suitability regarding their specific intended applications. End users should perform their own tests to determine suitability for each application.